How to Hang Inset Doors

12352 5F00 lead How to Hang Inset Doors

How to Hang Inset Doors

Install butt hinges perfectly and establish consistent, slender margins.

By Tim Johnson

Purchase the complete version of this woodworking technique story from AWBookstore.com.

Nothing signals skillful craftsmanship like an inset door with
elegant hinges and eye-pleasing margins. This challenging job leaves no
room for error: Uneven surfaces and unsightly gaps will tell the tale if
the hinges, door and frame don’t fit precisely. Like mastering hand-cut
dovetails, successfully hanging inset doors on mortised butt hinges is a
woodworking milestone. 

I’ll show you a three-step method for installing inset doors that
produces great results every time. First, you match the door to the
opening. Then you rout mortises for the hinges. And finally, you create
uniform, attractive margins between the door and frame. Of course, you
can skip the mortising step altogether by choosing different hinges (see
“No-Mortise Hinge Options, below”).

To complete the job, you’ll need a couple simple jigs, a mortising
bit, and a laminate trimmer. A laminate trimmer is a compact router
that’s a really handy addition to any woodworking shop. (If you don’t
own a laminate trimmer, this is a great excuse to buy one.) 

Round out your door-installing arsenal with a pair of secret
weapons—a plastic laminate sample swiped from the home center and a
double-bearing flush-trim router bit. This great new bit should be a
fixture in every woodworking shop.

Choose hinges

12352 5F00 hinge How to Hang Inset Doors

12352 5F00 hinge2 How to Hang Inset Doors

Your first task is to choose between extruded (also referred to as drawn or cast) or stamped hinges (see photos, above). Extruded hinges are machined and drilled, so there’s virtually no play between the knuckles or around the hinge pin. Stamped hinges are made from thinner stock. Their leaves are bent to form the knuckles that surround the pin. Extruded hinges will last longer, because their knuckles have more bearing surface.

I often use stamped hinges because they cost about one-third as much as extruded hinges and they’re available at most hardware stores. They work fine in most situations. Examine stamped hinges carefully before buying. If you notice large gaps between the knuckles and vertical play between the two hinge leaves, keep looking. Be aware that some stamped hinges are brass plated rather than solid brass. Hinges with loose pins make it easy to remove and reinstall the door, but they aren’t widely available.

Click any image to view a larger version.

12352 5F00 06 How to Hang Inset Doors

6. Rout mortises in the door stile. Locate the mortise at least one hinge length from the top. Because of its small size, a laminate trimmer works great for this delicate job.

12352 5F00 08 How to Hang Inset Doors

8. Rout mortises in the face-frame stiles using the mortising jig. You’ll need a laminate trimmer for this job, because the mortises are so close to the corner. 

12352 5F00 10 How to Hang Inset Doors

10. Rout the door to final length. Use a fence and a flush-trim bit with top- and bottom-mounted bearings to avoid blowing out the back edge. First, rout halfway using the top bearing.

This story originally appeared in American Woodworker May 2006, issue #121.

121MayCov How to Hang Inset Doors

May 2006, issue #121

Purchase this back issue.

Purchase the complete version of this woodworking technique story from AWBookstore.com.

 How to Hang Inset Doors

No related posts.

Comments are closed.